Owner's Manual

1. Mount the vehicle specific fuse holder rack to passenger side of engine bay near battery using a 10 mm socket. The forward mounting
hole on the fuse holder rack will use an existing factory M6 bolt, the rear mounting hole will use the included M6x1 bolt into an unused
factory mount location.
2. Run the pre-installed red power wire from the fuse holder and connect it to the battery positive terminal using a 12 mm socket. Using a
T20 Torx, install the red power wire into the open end of the fuse holder. Run red power wire behind the fuse box and down the engine
bay side of the firewall. Secure wire with included zip ties. Do not install the fuse at this time.
Using a T50 Torx, unbolt the front passenger seat. Lean passenger seat back and disconnect the 2 connectors from bottom of the seat.
P:1