Subwoofer Amplifier Installation kit 2018-Up Jeep Wrangler JL*, 2020-Up Gladiator JT* *Not compatible with factory amplified vehicles. Only designed for use in aftermarket radio installations. Utilizing small form factor amplifiers.
1. Mount the vehicle specific fuse holder rack to passenger side of engine bay near battery using a 10 mm socket. The forward mounting hole on the fuse holder rack will use an existing factory M6 bolt, the rear mounting hole will use the included M6x1 bolt into an unused factory mount location. 2. Run the pre-installed red power wire from the fuse holder and connect it to the battery positive terminal using a 12 mm socket. Using a T20 Torx, install the red power wire into the open end of the fuse holder.
. Pull back carpet and locate the floor grommet under the seat. Remove grommet. Using a ½ inch drill bit, drill hole in grommet. 4. Using a pry tool and 10 mm socket, unhook the door catch then remove door seal and kick panel cover. 5. 1. Unclip and remove the panel below the steering column. (Figure A), Unclip the climate control panel and set aside. (Figure B), Remove (2) Phillips screws securing the radio trim panel, then unclip and remove the panel.
See diagram on page 5 for overview 1. Run red power wire down firewall, and follow Jeeps frame watching for pinch points, or exhaust components. Locate the grommet floor hole. Secure wire with included zip ties. Slide grommet over red power wire and install grommet. 2. Mount the black ground wire to the factory ground point in the passenger kick panel with a 10 mm socket. Scrape paint away from ground mounting location to expose bare metal.
1. Mount the amp to amp rack, using hook and loop tape position rack in the vehicle with the rear bracket feet over the passenger seat rear bolt hole locations. 2. Terminate cables with proper connector for the style of amplifier being used. Connect cables and RCAs to the amp. We recommend using InstallBay PN: IBLUGT, and IBFCRIMPER to terminate the ferrules. 3. Connect RCA’s and remote wire to radio, then reinstall radio and dash. 4. Using a T20 Torx, install mini ANL fuse into the fuse holder. 1.
Vehicle layout P:5
Notes: ____________________________________ ____________________________________ ____________________________________ ____________________________________ ____________________________________ ____________________________________ ____________________________________ ____________________________________ ____________________________________ ____________________________________ P:6
Thank you for purchasing your Jeep Accessory from Metra Electronics! We’re excited to see your installs, also if you have any questions, comments, feedback on the product, please contact us at techsupport@metra-autosound.com 4/5/2022 Tech Support www.MetraOnline.com 386.257.
