Installation Guide

SWITCH SETTINGS:

The EC-3130, EC-3132 & EC-3142 ChekPoint controller o ers settable water  ow

control adjustment selections. These selections are set by con guring a bank of DIP

switches located behind the sensor to the settings shown on the tables below.

To access the DIP switches:

1. Shut-o the water supply at the supply stops.

2. Using the L-Key provided, remove the handle and body screws. If the pre-set

temperature plug is installed it does not need to be removed.

3. Remove the temperature lever and adapter from the faucet body. Note: the adapter

has an o-ring seal and may require pliers to pull out from the body. Protect the

chrome  nish on the adapter from the jaws of the pliers.

4. Remove the faucet body from the base by pulling the body straight up.

5. Remove the battery to access the bank of DIP switches.

Figure 6:

Access to Dip Switch

Settings

6. Set the DIP switches to the desired

settings described on page 9.

7. Replace battery.

8. Carefully reinstall the body straight

down onto the base.

9. Reinstall the lever handle assembly

and body screw.

General Instructions

5. Remove the faucet body from the base by

pulling the body straight up.

6. Install the chrome body plug into the hole

from the inner side of the body as shown

below. The smooth face of the plug will be the

exposed size. Press the plug until bottomed.

7. Carefully reinstall the body straight down

onto the base.

8. Reinstall the body screw.

9. Turn on the supply stops.

Figure 5

body plug