Installation Guide

5. Replace pop-up drain stopper in drain body, with ‘o’-ring in place,
and align stopper hole with guide and opening.
drain
stopper
fl ange
drain
body
align hole in
drain stop-
per with guide
rod opening
(pointed toward
back wall)
sink
6. Reinsert rod ball assem-
bly back into drain body and
through hole in drain stopper.
7. Insert pop-up stem through
hole in faucet body. Attach lift
rod to pop-up stem by insert-
ing stem through hole in lift
rod. Reassemble rod guide,
washer and nut, and tighten
fi rmly.
8. Adjust pop-up stem to correct height
by opening drain, and sliding lift rod
and rod clip at the same time onto rod/
ball assembly. Readjust lift rod screw
if necessary, hand-tighten.
rod/ball
assembly
drain
body
pop-up
stem
rod guide
washer
and nut
Side view
faucet and
pop-up
assembly
9. Make connection to supply
lines.
10. Turn on water supply and
check for leaks.
6
General Instructions