Installation Guide

5
Faucet Installation (B-2710 & B-2711)
(Refer to diagram below)
1. Shut off water supply and drain lines.
Clean sink surface throughly.
2. Install no.5 with no.2 on top of the deck
or sink.
3. Place no.3 and no.4 on the shank of no.5
and tighten fully.
3. Insert drain body from bottom of sink
drain hole, reassemble fl ange to drain
body, tightening as far possible.
rod clip
pop-up drain
stopper
nut
o-ring
stem
screw
rubber washer
fl ange
washer
gasket
lift rod
locknut
ball rod
drain body
4. Slide rubber washer on drain pipe up
against bottom of sink. Tighten washer
and locknut fi rmly against base for a tight
seal.
fl ange
drain pipe
drain
body
fl ange fl ush with
sink bottom
rubber
washer
locknut
sink base
Pop-Up Valve Installation
1. Remove pop-up drain stopper, with o-
ring and fl ange, from pop-up assembly.
2. Remove rod clip, lift rod, rod guide nut
and rod ball assembly from drain body.
5
deck
3
4
4. Connect water supply lines and check
for leaks.
2
washer
Faucet Installation (B-2701 & B-2703)
(Refer to diagram on page 2)
1. Shut off water supply lines. Drill a 1-1/2”
diameter hole in countertop where no.5 will
be installed.
2. Clean countertop and bottom of no.5. Ap-
ply putty to bottom of no.5.
3. If installing no.13, apply putty to bottom
contact face of no.13.
4. With no.14 and no.15 removed place hoses
and threaded rod at bottom of no.5 through
the 1-1/2” diameter hole.
5. Place no.14 and no.15 on threaded rod and
tighten.
6. Connect water supply and check for leaks.
General Instructions