CONGRATULATIONS on your purchase of the T-Rex Replicator Junior! Built on the same principles as its bigger brother, the Replicator Junior offers a bare-bones feature set in a smaller enclosure while keeping the same sonic performance, in all its analog, mechanical and magnetic glory. A tape echo works by recording and playing back audio on magnetic tape loop run by a motor. The time it takes for the tape to go from the record head to the playback head will determine the delay time.
MAINTENANCE The Replicator Junior’s moving parts as well as the tape heads WILL need a bit of cleaning every once in a while. If the unit is used on a regular basis, the tape cartridge will wear out faster and the various parts will need cleaning more often. In contrast to older tape echo units, the Replicator Junior is very easy to maintain and the cartridge can be replaced in seconds. Replacing the tape cartridge: Turn off the effect (motor stops) and take out the knurled screw.
and down in pitch by the Delay Time knob. For best results, the feedback should be turned up right after the note(s) you want to oscillate has been played. If the delays ring out before you turn the knob, the oscillation will be dirtier, noisier and not as evident. T-REX WARRANTY CONDITIONS TECHNICAL SPECS Input impedance T-Rex offers a 2-year warranty on all our products. In the unlikely event of a malfunction, please contact our technical support at service@t-rex-effects.
Made by T-REX Denmark, 2017 1 st edition 2017 Lars Dahl-Jørgensen Founder Sebastian Jensen Founder T-Rex Engineering ApS www.t-rex-effects.
