User Manual

MASTER VOLUME (VOL. EXP. PEDAL JACK)
For those players that want to use a volume pedal for controlling the overall output of the
unit, we incorporated an expression pedal input. This will allow you to turn down the in-
strument signal while allowing signals from the delay, reverb and the looper to be audible,
so that the tails of the effects are kept intact. The looper level remains unchanged, even if
you turn the instrument signal down.
Why not just use a volume pedal connected between the Soulmate Acoustic and the
amp/P.A.?:
Because you lose the unit´s ability to set the input impedance and the compressor (if on) will
react dierently depending on where the pedal is set. By controlling the volume internally, we
get all the good and none of the bad.
OUTPUT CONNECTIONS/CONTROLS
Output connectors :
Two unbalanced ¼” jacks (left/right) for connecting to amplifiers or unbalanced
inputs on mixers, audio interfaces, etc.
Two balanced XLR connectors (left/right) for use with stage boxes, mic inputs
on mixers, etc.
Ground lift:
The XLR outputs feature a ground lift switch that is useful if you have excessive hum/noise
caused by ground loops. If for example you are using an amplifier on-stage for monitor-
ing (using the unbalanced out(s)) while also being plugged in to the P.A. via the balanced
out(s), things can get noisy. Pressing the ground lift switch will break the ground loop and
remove the noise. If you can´t detect any noise in the setup, leave the switch in the “out”
position.
Level OUT:
This knob sets the output level of the entire unit and affects all outputs.
T-Rex warranty conditions
T-Rex offers a 2-year warranty on all our products. In the unlikely event of a malfunc-
tion, please contact our technical support at service@t-rex-effects.com before sending
us the product for repair. Read more about warranty conditions at www.t-rex-effects.
com/service
About T-Rex
Based in Vejle, Denmark, T-Rex Engineering makes classic and signature effects pedals
for the world’s best musicians. Our approach blends hi-tech innovation with old-world
craftsmanship – always in the service of killer tone.
EU regulations • Environment protection
T-Rex accepts and follows the regulations and directives issued by the EU. We find these
environment protecting regulations very good, and we are happy to follow them.
Input impedance 1M ohm/10M ohm, selectable
Output impedance (ohm) 330(xlr), 1,5K(1/4”)
Power supply 12VDC, center negative (included)
Minimum 11,5V DC
Maximum 12,5V DC
Current draw @12VDC 560mA max.
Max. input signal 3,5V p-p
Effect processor specs 24-bit, 48KHz, 1ms. latency
Looper specs
24-bit, 46KHz, 32-bit floating point internal
processing. Maximum 5,8 min. looping time
External connectors
Input, exp. shimmer, exp. vol, ¼” outputs (L/R),
XLR outputs (L/R), power inlet
Pedal size incl. knobs (WxHxD) 400 x 62 x 148 mm / 15,75 x 2,44 x 5,83 inch
Weight excl. packaging 2 kg / 4.4 lb
TECHNICAL SPECS
SUBJECT TO CHANGE WITHOUT NOTICE