User's Guide

Note: The donor unit is mounted using two 12” sections of standard profile Unistrut along with 4X 3/8”-

16 bolts, 4X 3/8”-16 strut channel nuts, and 4X washers.

Step 1) Fasten the 12” Unistrut sections to the rear of the repeater housing using with 4X 3/8”-16 bolts,

4X 3/8”-16 strut channel nuts, and 4X washers.

Note: The “closed” side of the Unistrut should rest flat against the back of the repeater housing.

Step 2) Once the 12” rail sections are attached, one strut mount routing clamp is attached to the reverse

side of each 12” section, which allows the unit to be mounted to a pole. If elevation adjustment is

required, slide the slip-on framing crossover fitting onto horizontal pole prior to inserting both ends into

the strut mount clamps.