Instructions

2
The pump is not suited to discharge saltwater, faces, inflammable, etching, explosive or other hazardous
liquids. Please observe the max. temperature of the liquids to be discharged stated in the technical data.
Inside the pump, lubricants are used which may contaminate the liquids being discharged in case of any
improper operation or damage of the device. The lubricants used are biologically degradable and non-
hazardous to health.
3. Technical Data
Model
CoverOne 1500 AUT
Mains voltage / frequency
230 V~ / 50 Hz
Nominal performance
20 Watt
Protection type
IPX8
Pressure port
AG 26,44 mm (¾“)
Max. flow rate (Q
max
)
1)
1.300 l/h
Max. pressure
0,16 bar
Max. delivery height (H
max
)
1)
1,6 m
Max. submersion depth 
1 m
Max. size of the solids being pumped
2 mm
Max. fluid temperature (T
max
)
35 °C
Max. cut-in frequency in one hour
30, gleichmäßig verteilt
Length of connection cable
10 m
Cable type
H05RN-F
Weight (net)
1,3 kg
Cut-in level
25 mm
Cut-out level
20 mm
Dimensions (L x D x H)
17 x 11 x 11 cm
Item no.
30441
1)
The values were determined with free, unreduced outlet.
4. Scope of delivery
The scope of the delivery of this product includes:
One pump with connection cable, one connection port, one operating manual.
Please verify that the scope of delivery is complete. Depending on the purpose of the application, additional
accessories may be necessary (please refer to the chapters titled "Installation" and “How to order spare parts“).
If possible, keep the packing until the warranty period has expired. Please dispose of the packing materials in an
environmental-friendly manner.
5. Installation
5.1. General installation information
During the entire process of installation, the device must not be connected to the electrical
mains.
The pump and the entire connection system have to be protected from frost.
All connection lines have to be perfectly tight since leaking lines may affect the performance of the pump and
cause considerable damage. If required, please use a suitable sealant to make the installation airtight.
When tightening threaded connections, please do not apply excessive force which may cause damage.
When laying the connection pipes, you should make sure that the pump is not exposed to any form of weight,
vibration or tension. Moreover, the connection lines must not contain any kinks or an adverse slope.
8