User's Manual
WIFI Alarm System
15
WIFI Alarm System
14
10.4.3 Mobile APP controls the host to delete remotes learnt
Keep pressing “Remote Controller” on its setting interface.(In IOS system, press
“Delete” symbol)
Dialogue window pops up, if user confirm to delete, press “OK”. App sends deleting
commands to host
APP returns to the remote setup interface, then obtains the quantity of remote
controllers coded again. If deleted successfully, the quantity of remote controller
would be zero.
As shown in the figures below:
As shown in the figures below:
10.4.4 Mobile APP controls the host to delete detectors learnt
In detector setup interface, Press detector’s “Deleting”icon in the list coded.
Dialogue window pops up, if user confirm to delete, press “OK”. App then sends
deleting command of corresponding detector to host
APP return to detector setup interface, then obtains the quantity of all detectors
coded again. The detectors deleted would disappear.
11.Learning With External Wireless Siren
11.1 By S1 button
Make the wireless siren into learning status. Press“S1”button till the two
led lights flash at the same time then loose it ,host will continuously emit
one-second signal to the siren.
11.2 By mobile APP control
The way of mobile APP control
Choose“Wireless Siren Setting”in“System Settings”menu.
Press“Trigger ”button in the interface of wireless siren setup,then App
sends wireless triggering signal to host if trigger succeed.
App shows “Trigger OK”.
As shown in the figures below: