User's Manual
Enter “System Settings” menu.
Press "Remote Setting" and enter the remote controller interface, APP would
obtain the Quantity of remotes already learnt with the host.
Press "Add Devices" button, enter the remotes learning interface.
Press the button "Learning”, send the host learning instructions of remotes.
Press any key of the remotes to learn, finish the learning, the host sends the APP
information of learning success.
APP pops up "Learn OK”, finish the learning.
APP returns to the interface of remote controller, and obtain again the quantity of
remotes already learnt with the host.
10.4.1 Query system setting
WIFI Alarm System
11
WIFI Alarm System
10
9.2 Mobile APP unbinding with host
Keep pressing S2 button of the host five times then release, the WIFI light fast
flashes 1 second, the host automatically terminates WIFI binding. In about 10~20s,
WIFI light flashes slowly which means unbinding is successful. After removing the
binding, APP needs distribution network again to match the alarm host.
10.Add or Delete Remotes and Detectors
10.1 How to add
Control host enters into the learning state: Host can enter the
learning state by three ways: S1 button of the host, SMS, and mobile
phone APP(More details please check the three points behind).
Please trigger the corresponding wireless devices within 20 seconds
or press any key of the remotes.
Learning results indicate as follows:
? Learning successful: three indicator lights flash 5 times
together, buzzer makes 2 long sounds.
? Already learnt: three indicator lights flash 2 times together,
buzzer makes 2 short sounds.
? No storage location or timeout (learn failure): 3 indicator lights
flash once together, buzzer makes 5 short sounds.
10.2 Control the host into learning state by S1 key
First keep pressing button to choose the devices to be learnt, then loosen the button,
enter learning state. Refer to below tablet:
Device to be learnt
Keep pressing S1 button to
choose the device to be learnt
Loosen S1 button to enter
learning state of the device
10.3 Control the host into learning state or
delete remotes/detectors by SMS
By sending an SMS to the host, control the host into the learning state or delete existing
remotes or detectors. Specific methods, see SMS settings part.
10.4 Control the host into learning state or delete
remotes/detectors by mobile APP