User's Manual
Inset SIM card: insert standard MICRO SIM card at slot according to the diagrams
(should be trimmed with big SIM card); Card inserting is OK when there is a ‘tick’
sound.
Power on: inert the main power supply at USB 5V jack to power the host.
Booting: at shutdown state, click S1 button then loosen, 3 indicator lights on at the
same time, booting OK.
Shutdown:at working state, long press S1 until 3 indicators flash at the same time,
then off in 0.1s, shutdown.
WIFI Alarm System
09
WIFI Alarm System
08
7.Use Beginning 9. Mobile APP Distribution Network/
Unbinding with Alarm Host
8. Parameter Initialization
Keep pressing S2 button above 10 times, until the three LEDs turn on at the same
time, it means initialization successful, the host cold starts. After initialization, all the
parameters set already would be back to the factory defaults, and eliminate all the
remote controllers and detectors learnt as well as network IP. Host would be stay at off-
line state; If need to be online again and recover central network state, you should send
out SMS and re-set IP.
The users take cautions using such function, generally you can apply if the host
parameter was set in a mess or some unknown remotes or detector were learned.
Notes: The following operations are based on APP; There would be some
different description with Android APP.
iOS
9.1 Mobile APP distribution network with host
Ensure the host and mobile phones in the same WIFI network.
Run mobile APP software, login the registered account at the user login interface
(new users need to register account number).
In the device list interface, press the top right corner "Airlink" button, enter the
intelligent configuration interface.
Press down S2 button of the host until the WIFI light flashes fast, then release, the
host enters into configuration state.
Enter the WIFI password, press the "OK" button, WIFI indicator light of the host
stops flashing; Configuration is OK.
After configuration’s OK, in equipment list interface, the APP will show the MAC
address of the host in the list box , a mobile phone can be configured with
multiple alarm hosts; select the corresponding MAC address to the host, and you
can control the different hosts
As shown in the figures below: