User's Manual

WIFI Alarm System
25
WIFI Alarm System
24
13.4 SOS
Remote control operation: Press the SOS button on the remote control [ ].
APP Operation: In the main menu, press the "SOS" icon.
Host Tip: 3 LED lights flash quickly 10 times, the buzzer makes 5 short sounds quickly ,
3 seconds later, the middle icon of the APP is updated as “SOS” icon, generating a
local sound and light alarm, meanwhile send an alarm SMS message or dial the pre-
set alarm phone number, meanwhile send alarm information to the network control
center.
As shown in the figures below:
SOS
13.5 Modify SMS to control user password
SMS operation: Send SMS 1234mm5678, “1234” stands for the user's password,
5678” is for the new password, must be four digits.
13.6 SMS operation feedbacks
Host’s name>:
Remote Operation Results
Current status: Arm / Stay Arm / Disarm
Power supply status: main power / backup (backup battery voltage)
14.1 SMS Alarm
14.Alarm and Remote Monitoring
The host supports multiple alarm types, when the alarm occurs, it would send the
corresponding alarm message to the user mobile phone number and push alarm
information to the mobile APP through the detector name defined in learning and even
send alarm information to network monitoring center while dial the user ’s phone
number , the user can monitor the scene once the telephone has been got through.
The host also supports the following alarm types:
? The host AC power failure (the host AC power fault lasts for 5 seconds, the alarm will
be valid).
? Back-up battery low power (in power fault state, if the backup battery voltage is
lower than 3.45V for 10 seconds, this alarm will be valid
? The main power restore
Host’s English name>:
The current alarm
Current status: Arm / Stay arm / Disarm
Power supply status: main power / backup (back-up battery voltage)
When the alarm occurs, the host sends alarm SMS to the preset phone numbers,
as follows:
14.2 Mobile APP receiving alarm process.
When the alarm occurs, the host push alarm information to the mobile phone
then the user enter the main menu of APP, APP’s middle icon status is changed to
red bell” symbol, and APP displays the current alarm type. The user can choose
"alarm message" icon to query for all user operation records and host alarm records
by pressing “Alarm Log”.
Door
SOS