User's Manual

WIFI Alarm System
21
WIFI Alarm System
20
12.4.3 Query alarm phone number setting
SMS format *6666*51*
PHONE set:
1:
2:
3:
4:
5:
REDIAL COUNTER:
SMS format: *6666*33*
DELAY set:
ENTRY:
EXIT:
SIREN:
12.4.4 Query various delay setting
SMS format: *6666*46*
SWITCH set:
ARM/DISARM BEEP:
ALARM BEEP:
ARM/DISARM SMS:
12.4.5 Query ON/OFF setting
SMS format： *6666*26*
DETECTOR learned:
REMOTE:
DETECTOR:
12.4.6 Query the quantity of remotes and detectors learnt
13.User Daily Operation
The user can operate the host at any way as follows:
? Operate by remote controller on site
? Remotely Sending SMS
? Remotely using a mobile phone APP
? Center Remote Control (valid only for GPRS network)
13.1 Arm
Remote control operation: Press the remote control Out Arm key [ ].
SMS Operation: Send SMS 1234bf , “1234” stands for the user's password. The host
will reply to the controlling phone with a message saying "Remote Arm success!".
APP Operation : In the main menu, press "Arm" icon, then select the delayed arming
time (Exit delay),3 seconds later, the device will return to Arm successfully, APP’s
middle status icons is updated as Arm.
Host Tip: 3 LED lights flash slowly once, and the buzzer makes long beeps twice, the
host indicator light starts blinking in turn in the exit delay status,the red LED light
will keep on when delay time is over, please leave the scene before the end of the
delay. If the "Arm / Disarm SMS notification switch" has been opened in the setting,
host will send a message saying "Arm success" to the preset phone.
In Arm state, all defense zones are into alert status, at this time once one defense zone is triggered, the
control panel generates a local sound and light alarm, and send alarm messages and make phone calls to
the pre-set phone numbers , at the same time push the alarm message to phone APP while send alarm
information to the network monitoring center.
As shown in the figures below:
Cancel O K