User's Manual

Operate alarm host: Main Menu WiFi Unbind Enter, the alarm host
displays “Unbinding”.
Waiting for 10-20 seconds, the alarm host unbinds with mobile phone
automatically. After unbinding, the mobile phone can not control the alarm host
until being configured again.
Unbind mobile phone APP with alarm host
Ensure the alarm host and mobile phone to be in the same WiFi network.
Run APP software, and login at the user login interface (new user is required to
register ID at first).
In “Device List” interface, press “Airlink” button on top right corner to enter into
the intelligent configuration interface.
Operate alarm host: Main Menu WiFi Airlink Enter, the alarm host
displays “Airlinking”, and enters into the 60- seconds countdown waiting
interface.
Select WiFi network listed in the APP and input password, press “OK” to start
configuration.
The alarm host displays “Airlink OK” to complete configuration. The MAC
address of the alarm host will appear in the APP “Device List”. One mobile
phone can be configured with several alarm hosts. Select the corresponding
MAC address of the alarm host, then the mobile can control the alarm host.
54
Install
Mobile phone APP
The concerned APP description is based on Andriod system, some description may
differs due to APP version or iOS system. All description is subject to installed APP
in mobile phone.
321
Refer to below diagram:
13
12
APP configuration with alarm host
Using mobile phone’s browser to scan QR code, then download the APP and install.
Add remote control via APP
Enter into “System Settings” menu
Select “Remote Setting”, all remote controll is listed in this interface.
Select “Add Devices”
Select “Start to learn”
Press any key in the remote control, the alarm host will send successful
information to APP, then learning is completed.
Return to “Remote Setting” to add more remote control.
.
.
.
“Learn OK” appears in APP.
Refer to below diagram:
MOBILE PHONE APP MOBILE PHONE APP