User's Manual

1.Initialization: All learnt remote control, wireless detector and RFID card are
remained, the other parameter is reset to factory default.
Set SMS contents:
2.Format of alarm phone number:
XXXXXX is phone number(Max. 18 digits), A is calling alarm switch(1-on,
0-off). B is SMS alarm switch(1-on, 0-off) .
*6666*43*
xxxxxxxxxxx,A,B
The user is required to edit SMS message according to below format, and send the
SMS message to SIM card in the alarm host.
Inquire/set parameter: Set function switch; Set alarm
phone; Set delay alarm
18
Refer to below diagram:
Remote SMS
Parameter setup
* * * *
Engineer Password
Address
Content
Address
Content
One SMS message can includes one or more address or content, but it must be
separated by * and the first and last data must be *. The address should be founded
of 2 digits. One SMS content can include maximum 160 bits. It is suggested to put all
contents in one SMS.
Address
Function Contents and Limit Factory Default
Times of redial
Times of auto answering ring
Revise user password
Revise system password
Initialization
Set alarm phone 1
Set alarm phone 2
Set alarm phone 3
Set alarm phone 4
Set alarm phone 5
Inquire GSM signal strength
1~255 times
1~255 times
0000~9999 4 digits
0000~9999 4 digits
Empty, refer to Note 1
Refer to Note 2
Refer to Note 2
Refer to Note 2
Refer to Note 2
Refer to Note 2
Empty
Once
Once(reserved)
Off
Off
Off
Off
Off
Empty
Set GPRS server IP address
Set GPRS APN
Set NTP IP
Set Greenwich time zone
This operation is only
valid for online GPRS.
Refer to Not 3
This operation is only
valid for online GPRS.
Refer to Not 4
Refer to Note 5
Refer to Note 5
Note: Below examples are based on default system password 6666
MOBILE PHONE APP
REMOTE SMS MESSAGE
19
Enter into System Setting Switch Setting, there are 3 options(Arming beep,
Alarm beep, Arm/disarm SMS) to select On/Off accordingly.
Enter into System Setting Alarm Phone Setting, click “ icon to activate
phone calling function when alarming, click “ icon to activate SMS function
when alarming.
Enter into System Setting Entry Delay Setting, to select the delay time in the
time roll. The unit is second.
”
”
21 2