Quick Start Guide


Toremovethelowerquick‐releaseplate,togglethelevertotheunlockedposition,andremove
thelowerquick‐releaseplatewhilepressingthesafetylockonthemountingplate.

4. Connectthecameracontrolcable.
Chooseapropercameracontrolcableaccordingthecameratype.Plugoneendof
thecable 连接
intotheRSSportofthegimbaland plugtheotherendintothecamera.
Bala nc ing
Balancing is required before shooting. Before balancing, make sure to power on the camera if
usinganopticalzoomlensandtoselectthefocallengthifusingavarifocallens.MakesureDJIRS
2ispoweredofforinsleepmodebeforebalancing.

1. Balancingtheverticaltilt
a.
Unlockthetiltaxis,andloosenthemountingplateknob.
b. R otatethetiltaxissothatthecameralensispointingupward.Check tomakesurethe
camera is not top or bottom‐heavy. If top‐heavy, move the camera backward. If
bottom‐heavy,movethecameraforward.
c.
Tighten the knob. The vertical tilt is balanced until the camera is steady while pointing
upward.