Owner's Manual

16
PC Connection - SCAL
The X20L has a calibration stored onboard to maintain settings of the X20L hardware. In order
for the X20L to work it must have a valid calibration present in the device and when shipping
from the factory a default cal is loaded to ensure it works out of the box. Calibrators who wish to
enable an Input to work in SENT decoding or setup custom CAN transmit will need to connect
live to the X20L.
A USB-C port is found at the back of the X20L which is IP67 sealed. Use a USB-C to USB-A
male/male cable to connect the X20L to the computer. The S-Suite software can be downloaded
from below.
https://www.syvecs.com/software/
After running the SSuite installer, open the program called SCal and click Device - Connect
A X20L device will be found as shown below, press Ok to proceed