Owner's Manual

Calibrations of the AWD ECU
Users have the ability to adjust all the controls of the Syvecs AWD Unit via our Scal program that’s part of SSuite. This can be
downloaded from
https://www.syvecs.com/software/
The USB port for communication is found under the main connector which is protected with a Allen key plug. Remove the plug and
connect a Micro USB Cable to the AWD Unit and the other side to a Windows Laptop or PC.
Open the Scal software and select Device - Connect Tab at the top. This will connect to the device and grab the calibration from it.
If the unit has just been updated then no Cal will be present and Users need to program defaults or load a base map.
IMPORTANT:
The AWD Ecu can be connected to and programmed outside of the car as it will power up of the USB cable alone. PLEASE NOTE: If
you are connecting the Usb to an Awd Ecu before the Unit is powered up from the car power systems it will enter a bootloader state
until a Device –Connect is preformed. If wanting to connect to the unit in the car then connect the USB after the Ignition is ON or
perform a Device –Connect first to bring the unit into main code.
Green Maps can be changed live, Blue maps require a Device – Program for the calibration change to be flashed into the device.
When all calibration work is done, users must do a Device – Program so the green maps which have been changed get flashed and
stored in memory.
Main Code Updates
Please watch the help video here - https://youtu.be/i0j4O9mN82Y