Owner's Manual

MagnetoResistive ABS Sensor Support
The Syvecs R35 AWD Controller supports magneto-resistive wheels speed sensors
which the factory car use. These can be connected direct to the Syvecs AWD
controller via Pins 9 to 12. When doing this another version of code can be loaded
into the controller via USB to allow the speed data collected from the sensor to be
transmitted on the OEM ABS Can Frames or as Bosch M4 ABS Frames.
This means users can remove the OEM ABS Computer from the car if wanted.
Connect as shown below
Syvecs AWD 26 Way Pin Function Nissan E41 ABS Connector Pin
9 FL Speed Signal 45
10 Fr Speed Signal 34
11 Rl Speed Signal 36
12 Rr Speed Signal 43
26 Ground 33, 37, 42, 46