Owner's Manual

Once
the carpet is lifted, remove the left ecu holder and
remove.
Unplug and remove OEM C
ontroller, replace with the Syvecs 997
When mounting the Syvecs AWD Ecu
it’s best to plug in the USB Cable at the same time and route the cable into the front if you are
planning to do live communication with the Unit. The USB port is found by removing the Hex plug on the front of the unit.
The AWD Unit will come pre loaded
with a base calibration that has default values which simulate an OEM AWD unit. Use Syvecs Scal
software to adjust. See last Page
the carpet is lifted, remove the left ecu holder and
you will find the OEM AWD Ecu
on top of the OEM Engine Ecu,
ontroller, replace with the Syvecs 997
AWD Unit in its place
by securing with double sided tape
it’s best to plug in the USB Cable at the same time and route the cable into the front if you are
planning to do live communication with the Unit. The USB port is found by removing the Hex plug on the front of the unit.
with a base calibration that has default values which simulate an OEM AWD unit. Use Syvecs Scal
on top of the OEM Engine Ecu,
unplug it and
by securing with double sided tape
or Ties
it’s best to plug in the USB Cable at the same time and route the cable into the front if you are
planning to do live communication with the Unit. The USB port is found by removing the Hex plug on the front of the unit.
with a base calibration that has default values which simulate an OEM AWD unit. Use Syvecs Scal