Owner's manual

How to use
The SY-HCT1X can be used cordlessly and while it is being charged.
Connect the adaptor to one end of the clipper and the other end to the wall outlet to charge the unit without the
base. The unit can also be charged using the charging stand. Connect one end of the adaptor to the charging
base and the other end to the wall outlet. Then place the unit on the charging base and the unit will charge. For a
complete charge it takes about 1.5 hours. When the unit is fully charged, it can be used continuously for more
than 45 minutes. The clipper has a LED digital display indicating the user the battery level while using and the
charge level while charging.
Before Starting the Haircut
• Select the comb attachment and the level of haircut desired (please see following sections on how to select
haircut level). Place the clipper besides the hair and push the switch button to ON to start using the hair
clipper. Carefully move in the same directions throughout the haircut.
• Check the clipper, making sure that there is no oil between the cutting blade teeth. Turn the unit on to
distribute the oil and to make sure it is running smoothly before using. Wipe off any excess oil. This should
be done before each use.
• In the case of cutting someone else’s hair, seat the person so the head is approximately at the eye level.
This allows ease of visibility while cutting and a better control of the clipper.
• Place a towel around the neck and shoulders of the person getting the haircut.
• Before cutting always comb the hair so it is tangle free.
Reminders
• Cut the hair in an even and slow manner. Use short strokes only and work gradually over the entire head.
• Always take off a little hair at a time; you can always trim off additional hair later.
• As you work, comb the hair frequently back into the style to which you are cutting.
• When cutting with this hair clipper it is better to leave the hair dry, not wet. With dry hair, it is much easier to
control the amount of the hair being cut.
• Cutting hair requires practice so it is always better to leave the hair longer for the first few haircuts until you
become used to the hair clipper levels and how much hair does each level cut.
How to use the comb attachment
First choose a desired comb attachment and then slide the comb attachment down over the main blade as
shown in the picture below. You may then adjust the hair cutting level by turning the dial clockwise or
anticlockwise.
To remove the comb attachment, gently push the comb upwards and slide it out as shown in the picture below
as well.