AC Hair Clipper SY-HC16 Instructions Manual
WELCOME Thank you for purchasing the new hair clipper SY-HC16. In order to benefit fully from this product please read the following instructions carefully. Store the instructions manual in a safe place for future reference. PARTS OF THE SY-HC16 BLADE ALIGNMENT Your clipper was carefully examined to ensure that the blades were oiled and properly aligned before leaving our factory. Blades must be realigned if they were removed for cleaning or after replacement.
If blade alignment is incorrect, add a few drops of oil to the blades, switch on the clipper for a few moments, switch off and unplug. Loosen screws slightly and adjust. Tighten screws after blade is aligned. To maintain your clipper in peak condition, the blades should be oiled after every haircut. Do not use hair oil, grease, oil mixed with kerosene or any solvent.
Do not place or store the appliance where it can fall or be pulled into a tub or sink. Do not pull, twist, or wrap the power cord around the appliance. Never insert any objects into the openings of the appliance. Before use, make sure that blades are adjusted properly. Do not place the appliance while it is operating on any surface, it may cause injury or damage. Do not use the appliance with a damaged comb, or with teeth missing from the blades as injury may occur.
STEP 2-BACK OF THE HEAD Use the 9mm or 12mm attachment comb to cut the back of the head (see diagram 2) STEP 3- SIDE OF THE HEAD Change to one of the shorter combs (3mm or 6mm) to trim sideburns. Then change to one of the longer combs (9mm or 12mm), and continue to cut to the top of the head (see diagram 3). STEP 4- TOP OF THE HEAD 1. Using the attachment comb 9mm or 12mm cut the hair at the top of the head from back to front against the direction in which the hair normally grows (see diagram 4).
STEP 5- THE FINISHING TOUCH 1. Finally, use the cutter without an attachment comb for close trimming around the base of the neck, the sides of the neck and the ears. 2. To produce a clean straight line at the sideburns use the hair clipper with the top parts of the blades pointing straight to the hair. (See diagram 7). 3. Press the clipper at right angles to the head, tips of the blades lightly touching the skin and work downwards. This way you will obtain a clean cut.
SHORT TAPERED STYLES′FLAT TOPS & SHORT CUTS 1. Starting with the longest attachment comb(12mm), cut from the back of the neck to the crown .Hold the attachment comb flat against the head and slowly move the clipper through the hair , as shown below (see diagram 8). 2. 3. 4. Use the same procedure from the lower side to the upper side of the head (as illustrated). Then cut the hair against the direction in which it grows and then level the cut from the sides.
DECLARATION OF CONFORMITY Manufacturer Name: Satyatrade S. L. Address: Pol. Ind. La Raya. C/ Guadalquivir, 2.
