User's Manual

FCC
USA
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a specific installation. If interference does occur to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to
which the receiver is connected.
• Consult customer care, the dealer, or an experienced radio/TV technician
for help.
Caution: Any changes or modifications to this device not explicitly approved by
manufacturer could void your authority to operate this equipment.
My pet does not respond when I press a button
• Make sure the Collar Receiver has been turned on.
• If your range has reduced from the first time you used the Dog Training
Collar, the battery(s) may be low in either the Remote Transmitter
or Collar Receiver.
• Many factors can impact the amount of range you have with the Remote
Trainer. For a list of these factors, see "How the System Works".
• Test the Collar Receiver. See "How to test the functions" for details.
• Increase the Stimulation Level. Refer to "How to find the best
Vibration/Shock Level for your pet" for more information.
• Make sure the Collar Receiver's Contact Points are placed snugly against
your pet's skin. Refer to "How to Fit the Receiver Collar" for more
information.
The Collar Receiver will not turn on
• Make sure the Collar Receiver has been charged. For the initial charge,
be sure to charge it for 4 hours. Subsequent charges only take 2~3 hours.
The Collar Receiver is not responding to the Remote
Transmitter
• Verify the Collar Receiver is on.
• If the indicator light is blinking rapidly, fully charged the Collar Receiver..
• If the first two solutions did not resolve your problem, see "How to syncing
the Remote Transmitter & Collar Receiver"
Trouble Shooting
21 22