User's Manual

CAREU P2 Personal Tracker User Guide
10
3.2 Communication Settings
The CAREU P2 communicates with your control center by either SMS or GPRS
(TCP/UDP).
1. SMS Configuration
Use AT$SMSDST command to set a SMS control center phone number or short code.
For example, if the SMS control center phone number is [phone], the
AT$SMSDST command to be issued into HyperTerminal should be:
AT$SMSDST=[phone]
Then you can try to use cellular phone or SMS gateway to send a SMS message to
the CAREU P2. Send a SMS message --> "AT$MODID?"
Device will response:
$MODID=101000001
OK
This shows a successful SMS communication between mobile phone and CAREU P2 .
2. GPRS Configuration
Set GPRS servers by using the following commands:
AT$APN=internet,username,password (APN=internet, Username=username,
Password=password)
AT$HOSTS=1,0,60.148.19.10,6000
(Server IP address = 60.148.19.10 and Port number =6000)
OK
AT$RETRY=5,10 (Message retry settings)
AT$IPTYPE=1 (Using TCP/IP mode)
AT$GPRSEN=1 (GPRS enable)
AT$HB=60,1 (Heartbeat setting)
Please refer to the CAREU P2 Protocol Document for more command details.
BV Certificate Use
2017/02/06 17:09