User's Manual

IntelliTrac A3 Series User Guide

This document contains confidential, restricted, and proprietary information. The document has been prepared for the

exclusive internal use of certain designated S&T employees and may not be duplicated or distributed, in whole or in

part, without the prior, written consent of an authorized officer of S&T.

- 12 -

(4) Type ATI command and press [Enter] key, the hardware and firmware version will be shown on the

HyperTerminal. If the HyperTerminal is shown like below, that means connection between the device

and PC is working properly. It is ready to send all configuration commands from now on.