User's Manual

IntelliTrac P1 Personal Tracker User Guide
Systems & Technology Corp. © 2008
This document contains confidential, restricted, and proprietary information. The document has been prepared for the
exclusive internal use of certain designated S&T employees and may not be duplicated or distributed, in whole or in
part, without the prior, written consent of an authorized officer of S&T.
- 13 -
2.3 Communication Settings
There are two communication modes for the IntelliTrac P1 Personal Tracker device to communicate to the
control center. One is SMS, and the other is GPRS (TCP/UDP). The device should be set communication
parameters before install the device to vehicle.
(1) SMS Configuration
Setting SMS control center phone number or short code by using AT$SMSDST command. For example,
the SMS control center phone number is [phone], issue the AT$SMSDST command in
HyperTerminal like below:
AT$SMSDST=[phone]
OK
Then you can try to use cellular phone or SMS gateway to send a SMS message to the A1 device.
Send a SMS message  "AT$MODID?"
Device will response：
$MODID=101000001
OK
(Type AT&W command to save all command parameters into the non-volatile memory of the device.)
AT&W
OK
This proves the mobile phone SMS connects successfully.