User's Manual

④. Save the setting using ‘X’ command and then put the ‘Mode Switch’ to ‘Active’.
⑥. Apply stage ②~④ procedures to the target WCS-232, and set the opposite BD_ADDR of two WCS-232
devices to TARGET_ADDR.
Appendix-A : Wait for user command mode
The Wait mode that waits for a command by a user performs search and connection of accessories. The
correspondent adapter shall be set up in Wait mode.
■ Search
It searches Bluetooth devices connected and serviced in the same coverage.
After execution of the command, the adapter address searched is displayed
■ Connect
Connection to a specific device
After execution of the command, the ready of communication is ended and the communication is enabled in
Active Mode.
Enter BD_ADDR.
Input ‘I’ command
Device address found
Search completed
① Input ‘T’
② Input ”000195999999”