User's Manual

■ Display Device Information
①. Type ‘V’.
②. All current information is displayed. At this time, verify that the values are identical to the ones you have once
set.
■ WCS-232 Pair Setting
WCS-232 always perform 1:1 communication in pairs.
The following example showing how to set up the destination WCS-232 address.
①. Set baud rate, data bits, parity and stop bit to 9600-8-NONE-1 at Hyper Terminal.
②. Connect one of WCS-232s to your PC serial port and put ‘Mode Switch’ to Setup Mode. and Record
displayed BD_ADDR.
③. Remove WCS-232(Used at stage ②) from your PC serial port, and connect the target WCS-232 and then set
the registered BD_ADDR using ‘A’ command.
Record BD_ADDR.