User's Guide

WARRANTY COVERAGE: SystemBase warranty will be limited to providing a software bug fix or a

software patch, at a reasonable time after the user notifies SystemBase of software non-conformance.

F.5. THIRD-PARTY SOFTWARE PRODUCT WARRANTY DETAILS

The warranty policy of the third-party software is conformed to the policy of the corresponding vendor

Certification and Safety Approvals FCC

Compliance Statement

This device complies with part 15 of the FCC rules. Operation is subject to the following two

conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may cause

undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device

pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications. However, there is no guarantee that interference

will not occur in a particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment on and off, the user is

encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antennae

-Increase the separation between the equipment and the receiver

-Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

-Consult the dealer or an experienced radio/TV technician for help.

FCC RF Exposure Statement

The equipment complies with FCC RF radiation exposure limits set forth for anduncontrolled

environment. This equitment should be installed and operated with minimum 20cm between the

radiator and your body.

FCC Caution

Any changes or modifications to the equipment not expressly approved by the party responsible for

compliance could void user’s authority to operate the equipment.