User's Guide

* When 10 bytes data are sent every intercharacter timeout, they are sent separately by 10 bytes at the

optimal value. If the intercharater timeout is set below the optimal value, the date will be put together

and sent by 20, 30, 40 bytes or more.

C.15. S28: Escape Sequence Character (default 43)

The decimal number of the ASCII code of escape sequence character can be controlled. The initial

value is 43, the ASCII code of ‘+’.

C.16. S31: Page Timeout (default 20)

This is the timeout in seconds to attempt connection with the ATD command. If this value is 0, WCS-

232 will attempt to connect without restarting. It must set at 5 second units.

C.17. S33: Inquiry Timeout (default 30)

This is the timeout in seconds to execute inquiry scan.

C.18. S37: Supervision Timeout (default 5)

This is the timeout to presume disconnection, which is set to 5 seconds initially. The smaller the value

becomes, the more quickly WCS-232 can detect an abnormal disconnection. But when the

communication is suspended, it may be regarded as disconnection. This value should be greater than

the Slave Disconnect Timeout(S57). (Slave unit depends on the value of master unit.)

C.19. S43: COD (default 001F00)

This value describes the sort of the bluetooth device and is editable.

Intercharacter Timeout

* Optimal Value(S23 x S26)

50ms

180

100ms

235

200ms

340