User's Guide

Parity=N/E/O (Default=N)

Stopbit=1/2 (Default=1)

Description

The Serial parameters can be set or changed only if SW config mode is selected in dip

switch. The factory default is 9600, N, 1.

To take effect the ATZ command must be used or Powercycle the unit.

Example

AT+UARTCONFIG,115200,N,1

B.3.5. AT+USEDIP?

Response



Purpose

Check the Baud rate set by the dip switch

Description

m=0: Dip switches are set to ‘S/W Config’

m=1: Please view the dipswitches to view your baud rate.

B.3.6. AT+BTINFO?

Response

 112233445566,DeviceName,Mode,Status,Auth,Encryp,FlowControl

 OK

Purpose

Display Bluetooth settings

Description

The current Bluetooth settings are displayed including BD address, Device name,

Operation mode, Operation status, Authentication, Data Encryption, and Hardware Flow

Control. The initial value of Device name is ‘WCSv2.0.0-445566’. WCS stands for WCS-

232, v2.0.0 for the version of firmware, and 445566 for the last 6 digits of BD address.

Mode=MODE0/MODE1/MODE2/MODE3

Status=STANDBY/PENDING/CONNECT

Auth=0/1 (Authentication is not activated when 0)

Encrypt=0/1 (Encryption is not activated when 0)

FlowControl=HWFC/NoFC

Example

 000B530011FF,SYSTEMBASE,MODE0,PENDING,1,1,HWFC

B.3.7. AT+BTINQ?

Response

 112233445566,FriendlyName,CoD