User's Guide

33
Figure 3-10 Connection Wizard Window
In this example we will refer to the two WCS-232s as SD1 and SD2 respectively. To use this menu,
please do the following:
Step 1. Connect SD1 and then push the START button.
Step 2. Disconnect SD1, connect SD2 and then push the Next button after setting up Slave
configuration. At this time, the dip switch value should be ATcmd mode. The flow control setting can
be changed only through dip switch.
Step 3. Disconnect SD2, once again connect SD1 and then push the Finish button. The pairing
configuration should be completed. Make sure that each WCS-232’s connect LED is on. At this point,
when both WCS-232’s restart the connection will be established automatically.