User's Guide

29
WCS-232 has 4 response messages, ‘OK’, ‘ERROR’, ‘CONNECT’, and ‘DISCONNECT’. In some cases,
these responses can affect the host system unexpectedly. To prevent this, user can set the Command
response to ON or OFF.
For WCS-232, hardware flow control can be configured only by dip switch. And parity, stop bit can be
configured only SW config mode. Thus H/W Flow Control option will not work in this case. When the
dipswitch value isn’t ATcommand mode, the Baud Rate menu will be disabled.
Click [Apply] button to apply any changes made to the WCS-232.
Connection(out) icon will show the following window to search and connect other Bluetooth devices.