User's Guide

data becomes large, the possibility of data loss becomes greater.

For large data transmissions, the use of hardware flow control is highly recommended.

3.6. Reset to Factory Defaults

To set all the configuration settings to its factory default parameters, press the reset button, depicted in

Fig. 3-1. Press and hold (for at least 1 sec) the reset button with a narrow pointed tool like paper clip.

Reset works only when power is on.

3.7. Dipswitch

With the combination of 4 slot dipswitches, baud rate and hardware flow control can be set.

Figure 3-1 The WCS-232 Dipswitch

Upper 3 dipswitches are used for setting the baud rate, and bottom dipswitch is used for setting hardware

flow control option. If the baud rate needs to a baud rate not shown below, WCSConfig or terminal

program should be used to set these speeds. To set a baud rate not shown below the dipswitches

should be in the S/W Config setting. When in the S/W Config setting the baud rate will go back to 9600

as default.

Table 3-4 Baud rate Settings by Dipswitches

Baud rate

2400

4800

9600

19.2K

38.4K

57.6K

115.2K

S/W

Config

Pairing Button

Dip switch

Reset