WCS-232_v6.0_User Manual_Eng_DM v1.0.1

WCS-232 v6.0 User Manual
61
C.14. S26: Intercharacter Timeout (default: 0)
Set the inter-character time interval used to separate data sent from the serial port. If no additional data is received
over his time, data is sent to the client.
S23=1 x S26=50 : Timeout-> 50msec
S23=2 x S26=50 : Timeout-> 500msec
S23=3 x S26=3 : Timeout-> 300msec
Intercharacter Timeout
* Optimal Value(S23 x S26)
50ms
180
100ms
235
200ms
340
This is a minimum time setting value when separating and sending 10bytes of data without being lumped. Reducing
this value may result in sending data massed together in 20, 30, and 40 bytes.
C.15. S28: Escape Sequence Character (default: 43)
Indicates the decimal value of the Escape sequence character. Default value is 43, indicating ‘+’.
C.16. S31: Page Timeout (default: 20)
Indicates the Timeout value used when attempting connection by ATD command. It can be set per 5 seconds. If the
value is 0, it continuously attempts to connect without rebooting.
C.17. S33: Inquiry Timeout (default: 30)
Indicates the searching time, which can be set per seconds.
C.18. S37: Supervision Timeout (default: 5)
This is the time takes to process the connection termination of there is no Bluetooth communication. Units are
seconds and default value is 5. If this value is set to small, Bluetooth connection can be detected as quickly as
possible. But even if the connection is temporarily unavailable due to external factors, it will terminate the connection
as regarding the connection lost. Also, it must also be bigger than Slave Disconnect Timeout(S57) value (slave follows