WCS-232_v6.0_User Manual_Eng_DM v1.0.1

WCS-232 v6.0 User Manual
49
to. If the connection has not been made, or has been disconnected after the connection, it
will be in a command waiting state. If you type to=0, you will be in the connection waiting
state indefinitely until the connection is made, and if disconnected even after the
connection, it will not return to the command waiting state and will be in the connection
waiting state.
If the connection is successful, it outputs a 'CONNECT' response message and the
counterpart BD address, and if it fails to connect within time, it outputs a 'ERROR' response
message. Not available in Remote mode.
Example
AT+BTSCAN000B530011FF,30
B.3.20. ATD
Response
 OK
 CONNECT 112233445566
or
 OK
 ERROR
Function
Reconnect to the most recently connected Bluetooth device
Description
It stores the address of the most recently connected Bluetooth device, so you can simply
try to reconnect without entering the address.
If the connection is successful, it outputs a 'CONNECT' response message and the
counterpart BD address, and if it fails to connect within time, it outputs a 'ERROR' response
message. Not available in Remote mode.
B.3.21. ATD112233445566
Response
 OK
 CONNECT 112233445566
or
 OK
 ERROR
Function
Connect to a Bluetooth device with a specific address
Parameter
112233445566 = BD address
Description
Attempt to connect by specifying the address of a particular Bluetooth device. The
Bluetooth device you are trying to connect to must be in the connection standby state for
the connection to be made. The connection attempt will be made for about 5 minutes and
automatically performs the authentication procedure when the authentication is required
during the connection process.
If the connection is successful, it outputs a 'CONNECT' response message and the