WCS-232_v6.0_User Manual_Eng_DM v1.0.1

WCS-232 v6.0 User Manual
47
slave.
Use ATOx (x=1-4) command to resume communication with a specific slave, and ATObdddr
command to resume communication with the slave with a corresponding address.
Description
Use the command when you want to switch from the online state to command standby
state using Escape sequence character, and then re-switch to online state, send and
receive data. Not available in Remote mode.
Example
ATO
ATO4
ATO000195000001
B.3.16. AT+BTCANCEL
Response
 OK
Function
Terminate the processing task
Description
Force terminate search attempts, search wait, connection attempt and connection wait
operations. If the operation ends normally, it turns to the command standby state. Not
available in Remote mode.
B.3.17. AT+BTSCAN
Response
 OK
 CONNECT 112233445566
Function
Turn into search/connection standby state
Description
By turning into search standby state and connection standby state, it allows other Bluetooth
devices to search for and connect it. This command has the same effect as
AT+BTSCAN,3,0.
When disconnected, it returns to search/connection standby state. Therefore, you must use
the AT+BTCANCEL command to change to the command standby state.
If the connection is successfully made, it outputs the 'CONNECT' response message and
the counterpart BD address. Not available in Remote mode.
B.3.18. AT+BTSCAN,n,to