WCS-232_v6.0_User Manual_Eng_DM v1.0.1

WCS-232 v6.0 User Manual
46
device. AT command is not entered in online status. The only accepted command is '+++'
and this character string is not printed on the screen.
When WCS-232 receives the '+' character from the host, it stops sending and waits for the
next character. If the second character is '+' and the third character is '+', then it switches to
Command Standby status. If the second or third character is other than '+', the transfer
resumes from the first '+' character. If there is a '+++' character string in the transmission
data, there may be an unintended change in operation status.
Also, when the data transmission has stopped receiving the ‘+’ character at last, WCS-232
does not send data and wait, so you should check for abnormal operation possibilities. In
this case, AT+SETESC command can solve the problem by changing ‘+’ to another
character.
'+' is the Escape sequence character set as default. Not available in Remote mode.
*Caution: In low-power mode, the '+++' string cannot switch the mode from online to
command standby. Input of '+++' string in low-power mode in online state can cause
unexpected errors.
B.3.14. AT+SETESC,nn
Response
 OK
Function
Change escape sequence character
Description
Escape sequence character is used to switch from online to command standby status, and
'+' is set to the initial value. When three ESCAP sequence characters are received in a row,
the operating status switches.
nn is the ASCII code decimal value of the Escape sequence character you want to change,
and must be the printable character present on the keyboard.
Example
AT+SETESC,42
 OK
B.3.15. ATO (ATOx, ATObdaddr)
Response
- (none)
Function
-Change operating status from command waiting status to online status
-Change to online status with specific slave in multi connection mode
In multi connection mode, ATO command resumes communication with last communicated