WCS-232_v6.0_User Manual_Eng_DM v1.0.1

WCS-232 v6.0

User Manual

Description

Factory default values are 9600, N, 1. The dip switch must be set to SWConfig mode for

application. You must reset software or turn the power off and on to take effect after the

change. The flow control option can only be changed with the dip switch.

Example

AT+UARTCONFIG,115200,N,1

B.3.5. AT+USEDIP?

Response

 m

Function

Set the Baud rate and verify whether it is in use with the dip switch

Description

m=0: If the transmission speed combination of the dip-switch is 'SWConfig'.

m=1: If the transmission speed combination of the dip-switch is set to a specific

transmission speed

B.3.6. AT+BTINFO?

Response

 112233445566,DeviceName,Mode,Status,Auth,Encryp,FlowControl

 OK

Function

Display Bluetooth related setting values

Description

Used to refer to Bluetooth settings. It displays BD address, device name, operation mode,

operating status, whether authentication, encryption or hardware flow control is enabled.

Initial value of FriendlyName is as ‘WCSv2.0.0-445566’. WCS stands for WCS-232, v2.0.0

for firmware version, and 445566 for the back six digits of the BD address.

Mode=MODE0/MODE1/MODE2/MODE3

Status=STANDBY/PENDING/CONNECT

Auth=0/1 (disable/enable)

Encrypt=0/1 (disable/enable)

FlowControl=HWFC/NoFC (enable/disable)

B.3.7. AT+BTINQ?

Response

 112233445566,FriendlyName,CoD

 OK

Function

Search for peripheral Bluetooth devices waiting to be scanned