WCS-232_v6.0_User Manual_Eng_DM v1.0.1

WCS-232 v6.0 User Manual
42
B.3. Command Description
B.3.1. ATZ
Response
 OK
Function
Reset software
Description
Same effect as turning the power switch off and on. The connection to other Bluetooth
devices is disconnected and all work in progress stops. The status after a reboot is
determined by the operation mode set. Some AT commands requires software reset to take
effect.
B.3.2. AT&F
Response
 OK
Function
Reset hardware
Description
Same effect as pressing the reset button. Returns all set values to factory default. All stored
data such as BD address will be deleted.
B.3.3. AT
Response
 OK
Function
Check the connection with the host
Description
Check if it is connected properly with the host. The serial port settings must match as well
as the physical connection between the host and WCS-232. If not connected properly, no
response or abnormal character strings output.
B.3.4. AT+UARTCONFIG,Baudrate,Parity,Stopbit
Response
 OK
Function
Set serial port
Parameter
Baudrate = 1200/2400/9600/14400/19200/38400/57600/115200/230400/460800/ 921600
(Default=9600)
Parity=N/E/O (Default=N)
Stopbit=1/2 (Default=1)