WCS-232_v6.0_User Manual_Eng_DM v1.0.1

WCS-232 v6.0 User Manual
33
ATO
Resume communication with the last slave you were
communicating with
ATOx (ATO1, ATO2, ATO3, ATO4)
Resume communication with the slave of the
corresponding TASK
ATObdaddr (ATO000195000001)
Resume communication with the slave of the
corresponding address
Table 4-4 ATO
4.4 Notes
-In Multi-Drop mode, communicating large amounts of data without flow control can result in data loss. Especially,
bidirectional communication can cause frequent disconnection and reboots to maintain multiple connections.
Therefore, sufficient environment testing is required before application.
- It is recommended not to include unused addresses in S-Register 46, 54, 55 or 56. Continuous attempts to connect
to inaccessible slave can lead to poor product performance. Disconnect message may be continuously displayed by
performing force connection stop for connection stability.
-Node Switching mode provides almost same performance as 1:1 single connection mode.
-Hardware flow control is recommended for both Multi-Drop and Node Switching modes.