WCS-232_v6.0_User Manual_Eng_DM v1.0.1

WCS-232 v6.0 User Manual
32
4.3 AT Commands
AT commands available in multi connection mode are shown below.
4.3.1 AT+MULTI,n
Select a multiple connection mode. Please refer to Table 4-1 for more information.
4.3.2 AT+MLIST?
It shows the current mode, connection status and slave address.
4.3.3 ATHx, ATHbdaddr
In multi connection mode, you can selectively disconnect all or certain slave connections through ATH commands.
ATH
Disconnect all slaves
ATHx (ATH1, ATH2, ATH3, ATH4)
Disconnect only the slave with corresponding TASK
ATHbdaddr (ATH000195000001)
Disconnect only the slave with corresponding address
Table 4-3 ATH
4.3.4 ATOx, ATObdaddr
In multi connection mode, you can resume communication with the last communicated slave or specific slave using
ATO commands(only applicable in Node Switching mode).
at+mlist?
CURRENT MODE: MULTI DROP
TASK1 – 000195000001
TASK2 – 000195000002
TASK3 – DISCONNECT
TASK4 - 000195000004
OK