WCS-232_v6.0_User Manual_Eng_DM v1.0.1

WCS-232 v6.0 User Manual
31
4.2 Configuration
All slaves must be in connection standby state (Mode 3 or 2) and master attempts to connect to each slave.
First, wsitch to the desired multiple access mode with AT+MULTI,x command, which will be automatically reboot after
performing.
AT+MULTI,0
Single Connection mode
AT+MULTI,1
Multi-Drop mode
AT+MULTI,2
Node Switching mode
Table 4-1 AT+MULTI,x
Manual Connection
Automatic Connection
ATD000195000001
CONNECT000195000001
+++
OK
ATD000195000002
CONNECT000195000002
+++
OK
ATD000195000003
CONNECT000195000003
+++
OK
ATD000195000004
CONNECT000195000004
+++
ATS46=000195000001
OK
ATS54=000195000002
OK
ATS55=000195000003
OK
ATS56=000195000004
OK
AT+MULTI,1 or AT+MULTI,2
OK
AT+BTMODE,1
After reboot, master attempts
connection automatically
Table 4-2 Multi connection mode settings
Enter slave address to four S-Registers(S46, S54, S55, S56), set master to Mode 1 to keep the connection stable.
After rebooting, if the registry contains an accessible slave address, the message AUTO CONNECT will be displayed
behind the corresponding TASK.
TASK1 OK – AUTO CONNECT
TASK2 OK
TASK3 OK – AUTO CONNECT
TASK4 OK