WCS-232_v6.0_User Manual_Eng_DM v1.0.1

WCS-232 v6.0 User Manual
29
3.12 Terminal Program
A terminal program is a program that controls or sets up serial ports. There are commercial programs such as
TeraTerm
TM
in addition to HyperTermnial provided by MS Windows. In terminal program, WCS-232 can be controlled
and set up with AT commands. This manual describes the methods using HyperTerminal. If the HyperTermnial is not
installed, it can be installed in Control Panel – Add/Remove Program. Please refer to MS Windows Help for more
information.
Go to Start-Program-Accessories-Communications-HyperTerminal and select HyperTerminal. After running it, select
the serial port to which WCS-232 is connected. Enter the same settings as in WCS-232 in the serial Port Settings
window as follows. If the setting is not correct, an error message appears or do not operate properly.
Figure 0-14 HyperTerminal
Plug WCS-232 into a serial port on the host computer and power it on. Check if the Mode LED is illuminated (Please
refer to 3.2).
Go to File-Properties-Settings-ASCII Setup and select “Echo Typed Characters Locally” optoin to see the characters
you enter on the host PC keyboard on the terminal screen. You can now change the WCS-232 settings by entering
AT commands. Please refer to Appendix. A for extended AT commands provided by WCS-232.
Example of using AT commands
at+btinfo?
00015B446655,WCS232v2.0.0-446655,MODE0,STANDBY,0,0,NoFC
OK
atd 000195000001
OK
CONNECT 000195000001