WCS-232_v6.0_User Manual_Eng_DM v1.0.1

WCS-232 v6.0 User Manual
28
In this manual, two WCS-232 devices are described as WCS-232#1 and WCS-232#2.
Step1. Connect WCS-232#1, set up as a master and click Start button.
Step2. Remove WCS-232#1, connect WCS-232#2, set up as a slave and click Next button. At this point, place
dip switch in ATcomd mode. Flow control can also be set with the dip switch only.
Step3. Remove WCS-232#2 and click Finish button. If the Connect LEDs of WCS-232#1 and WCS-232#2 turn on,
the setup is complete. Now WCS-232#1 and WCS-232#2 is automatically connected(for the WCS-232 series
with a pairing button equipped, you do not need to use the Connection Wizard function).