WCS-232_v6.0_User Manual_Eng_DM v1.0.1

WCS-232 v6.0 User Manual
24
Figure 0-6 Device Setting screen
WCS-232 supports Authentication and Encryption. When turning the authentication option, you must enter pin code.
At this point, the master and the slave device share the pin code. To connect WCS-232 to another Bluetooth device
which requires the authentication, you must know the pin code of the device. Most Bluetooth devices have a default
pin code of 1234 or 0000. For WCS-232, the default pin code is 1234.
Encryption is a feature that enhances wireless security, which makes master and slave devices transmitting encrypted
data. If one side requests the encryption, the other device accept the request.
The command response options have four responses, 'OK', 'ERROR', 'CONNECT', and 'DISCONNECT', depending
on the change in WCS-232 operation mode or use commands, which in some cases affects host device. To prevent
this, user can turn the response function on and off. When pairing with dip switch, the response function is
automatically turned off.
For WCS-232, the hardware flow control option can only be turned on and off with the dip switch. Also in dip switch
mode, use cannot set Parity and Stop Bit(They must be set after changing to SWconfig mode). Like this, options that
cannot be set will be disabled depending on the model. Only pressing Apply button will actually reflects the changed
settings to WCS-232.