WCS-232_v6.0_User Manual_Eng_DM v1.0.1

WCS-232 v6.0 User Manual
21
3.9 Remote Setup Mode
WCS-232 supports setup mode through remote access. After accessing to WCS-232 through Bluetooth, without
sending any data, send the escape character (default value: +) three times in a row to operate in remote setup
mode.
Once accessed to remote setup mode, enter the password using “AT+PASS” command. The default password is
“0000” and can be changed using “AT+CHPASS” command after password authentication. If an incorrect password
entry occurs three times during the password authentication process, or if three inputs occur without entering
password, it will terminate automatically. It will also terminate automatically if there is no input for 2 minutes after
accessing remote mode.
When the password authentication process is normally completed, the message “Remote Configuration Enabled”
will displayed and can be set remotely. The commands “ATH”, “ATO”, “ATD”, “AT+BTSCAN”, “AT+BTINQ?” and
“AT+BTCANCEL” are not available in remote mode.
Example of running remote setup mode
3.10 Utility
The setup utility can be downloaded from SystemBase website(www.sysbas.com).
Program
Purpose
Supported OS
WCSConfig
Configuration
MS Windows 98SE or above
Table 0-9 Configuration Program
CONNECT 000195000001
+++
Please Enter Password
AT+PASS=0000
Remote Configuration Enabled
AT+BTINFO?
000195000001,WCS232v2.0.3-095515,MODE0,CONNECT,0,0,HWFC