WCS-232_v6.0_User Manual_Eng_DM v1.0.1

WCS-232 v6.0 User Manual
18
3.8.2 1:Other Bluetooth Device Connection
The pairing button on WCS-232 makes easy connection between WCS-232 and other Bluetooth devices.
Step1. Turn on WCS-232#1 and press the reset button for more than 2 seconds for factory reset. The Mode LED
turns on.
Step2. Press the pairing button on WCS-232#1 for more than 2 seconds. Mode LED flashes green 3 times for 3
seconds. Check it and leave the power on.
Step3. Through software or use interface of the Bluetooth device, search and connect WCS-232#1.
Step4. When the connection between WCS-232#1 and the user's Bluetooth device is complete, the Connect LED
on WCS-232#1 flashes every 1 second. Then it can communicate with the connected Bluetooth device.
Step5. Even rebooting WCS-232#1, it turns to the status waiting for connection from the last connected Bluetooth
device. It can be reconnected from the user Bluetooth device.
WCS-232#1
Status
LED
Other Bluetooth Device
Status
1. Press the reset button for
more than 2 seconds
Mode 0
Mode LED turns on
2. Press the pairing button for
more than 2 seconds
Mode 3
Mode LED flashes 3 times
every 3 seconds
3. Search and connect
WCS-232#1
4. Connection complete
Slave
Connect LED flashes every 1
second
4. Connection complete
Master
Table 0-7 Connection process with other Bluetooth device using pairing button
3.8.3 1:4 Connection
WCS-232 also supports multiple connections up to 1:4 in Multi-Drop mode using pairing buttons. In this manual, one
master WCS-232 and four slave WCS-232s are marked as master, slave1, slave2, slave3 and slave4.
Step1. Turn the master on and press the reset button for more than 2 seconds for factory reset. Repeat the same
action for slave1, slave2, slave3, and slave4 to be connected to the master. The Mode LED turns on.
Step2. Press the pairing buttons of slave1, slave2, slave3 and slave 4 for more than 2 seconds to change to Mode
3 before connecting. Mode LED flashes green 3 times every 3 seconds.
Step3. Press the pairing button of master for more than 2 seconds to change to Mode 3. Mode LED flashes green 3
times every 3 seconds.
Step4. To connect to slave1, press the pairing button of the master for more than 2 seconds to search and connect