WCS-232_v6.0_User Manual_Eng_DM v1.0.1

WCS-232 v6.0 User Manual
16
3.7 Dip Switch
The WCS-232 has four dip switches which can control the flow control and communication speed(bit/sec).
Figure 0-1 WCS-232 Dip Switch
From the front, the upper three dip switches are used for bit/sec settings, and the bottom dip-switch is used for flow
control settings. If the setting values are out of dip switch setting range, it must be set using WCSConfig or terminal
program, and the dip switch combination must be set according to SW Config before use. If set as, the communication
speed will be initialized to 9600.
Table 0-4 Bit/Sec setup with dip switch
Table 0-5 Hardware flow control setup with dip switch
*Note: Communication speed of 1200 and bit/sec of 230k cannot be set with dip switch. At this time, please set the
dip switch to S/W Config and set using WCSConfig or AT Commend. Please refer to WCSConfig manual and
Appendix B.3.4 AT+UARTCONFIG, Baudrate, Parity, Stopbit.
Pairing Button
Dip switch
Reset